Dunlavy SC IVA X-over resistor values

First mark them carefully - so you know exactly where they are mounted. Then take them out (solder gun and sucker tool) and simply measure them with a multimeter. You may need to buy several resistors to find something that is very close. Normally resistors have +/- tolerances. Good luck - and make sure you pay attention to the power ratings too.

Or just look at the color rings. Plenty of websites where you can decode the colors. The values may have drifted over the years so what you measure may not be within tolerance of the nominal value. Also, if the quality of you solder joints is anything less than the factory, it could negate any advantage of a better resistor.

Shadorne, why can't you just measure them in place at the shoulders without removing them? I didn't think it would throw it off that much.

Thank you all for this. I do appreciate it. I'm new to this. I did have the connections to the actual speaker elements soldered and that made a nice improvement in the sound. Removed a kind of rizz or roughness I had not noticed until it was gone. These speakers have a wonderful top to bottom consistency or coherence I haven't heard before in a cone speaker. I have heard other speakers do certain things better but not overall. The bass quality is very accurate as well. Again, thanks for your input and if you have more data on this it would be welcome. This speaker is worth every minor improvement added to it. Jonathan

Keep in mind that Dunlavy chose resistor values on a per-speaker basis, choosing slightly different values until the speaker measured just right. Therefore, you may not find a schematic with specific values and one person's set most likely has slightly different values than another set.

Many of the sand resistors on the xover are glued one on top of another in parallel, so one would need to remove them to be able to read the values (they do not have color band indicators on them as Ge5556 suggests). Also, since many of them are connected in parallel, in-circuit measurements are not recommended. The best way to find the values would be to remove them and read the markings on the top of the package or measure them individually.

I too faced this same dilemma with my pair of SC4a's and after much research and thought, decided not to monkey around with changing them out. If you do want to take the plunge, use 10W non-inductive resistors such as wire wound Mundorf's.

Two tweeks that I made to the crossovers that made a nice improvement in sound quality was to replace the binding posts with Cardas CCGR-L type and coat the components with AVM (Anti Vibration Magic) available from AuDIYo.

Finally, as an aside from your topic, placing the speakers on Star Sound Sistrum SP-101 stands makes a big difference in sound quality. That is what I did and love the stands (looks cool too).

email me offline if you want to chat.