Wilson Audio MAXX series III

I went to listen to MaxIII in show room the other day. It was driven by all solid state gears. It was very dynamic with lots of presence and great bass. However I did't feel it was musically satisfying. Maybe it should be mated with tube amps?

However I did't feel it was musically satisfying. Maybe it should be mated with tube amps?

Or maybe a myriad of other possibilities.

I wonder if the Maxx III can be satisfactorily driven by SET amps, specifically the 18wpc Lamm ML2.1? Some people have no problem driving the Alexandria with the ML2.1. Has anyone tried the Max III and Lamm ML2.1?

The Maxx 3's are so new, might be hard to get this combo you're asking about.

I plan to try my Maxx 3's with a single BAT VK75SE vs my current 150SE's over the Christmas/New years break. If it works out, I'll sell one amp and use the other to fund some new purchase or payoff bills (more likely(

The Maxx 3's are effortless with the BAT 150SE's...

Wilson audio says the Maxx 3 is an easier load than the Maxx 2 even though the specs indicate the Maxx 3 is 91 dB vs the 92 dB for Maxx 2. And the published nominal impedance value of 4ohm is the same. I wonder what makes the Maxx3 an easier load.