1. Home
  2. amps-preamps
  3. 1430857781

Update on my Coincident Dynamo 34SE

Hi everyone,

A while back many of you gave me guidance on some hum issues I had with my new Coincident Dynamo. I ended up sending it back to Coincident for service. They said the filter caps were the problem and replaced them. I got it back today, plugged it in, and….the hum started up right away. It is not only just as bad, now it's equally bad in both channels (it was worse in the right channel before). I have to imagine that the techs listened to the amp after changing the filter caps, so perhaps this level of noise is normal?

I'm somewhat new to single ended tube amps, and I know that there is some hum associated with them. However, I can hear the hum from 20 feet away. It makes headphone listening impossible. It's also not going to work for near field listening at my work desk. From about 8 feet away in my listening chair, the hum is audible during very quiet passages and between songs. I guess it's just not meant to be...

I guess this falls under the "live and learn" category.

Scott
smrex13
smrex13 OP
423 posts
 
Thanks for all the suggestions and feedback. I'll try to answer most of the questions here. I haven't had the chance to listen to it in a friends system yet.

1. Yes, I send the tubes with it for the repair.

2. The level of the hum does not change when the volume control is moved.

3. The Emotiva DC Offset strip did not make any difference.

4. Yes, it buzzes with no sources plugged into it.

5. I have another SE tube amp (Musical Paradise) that has no hum issues when in the system.

6. Yes, the hum can be heard both at the amp and at the speakers.

7. I'm going to try to hook it up today in various places in the apartment with just headphones to see if I get the same hum everywhere.

8. I can't tell whether the hum is coming from the power or output transformers.

I'll experiment a little more tonight…

Thanks again,
Scott
rebbi
1,319 posts
 
Scott,
I know this is cold comfort, but like Roxy54, I have a SET amp - same one, the Audio Note Kits Kit 1) and it's dead quiet, no hum at all. So you certainly should not be getting any hum with this amp, at least not because it's single ended.
I know first hand that problem solving can be tricky and frustrating but you'll figure it out and, as Coincident's customer service is said to be first rate, I've no doubt they'll stand behind you.
FWIW, I had a nasty ground hum for years in my analogue side that I was certain must be due to a problem with my Bottlehead Seduction phono preamp, which I also built from a kit. Turns out that the problem was a broken ground wire in the tonearm cable of my turntable. Local service tech fixed it and tightened up the tonearm and now the hum is completely gone. So, try to be both patient and persistent!
mapman's avatar
mapman
15,679 posts
 
" Yes, it buzzes with no sources plugged into it."

Same noise as with source plugged in (hum) or different (buz).

Buz with no input attached is not uncommon and could be normal.

Hum is not normal should not be considered part of the experience in any case, SET or otherwise.

If not the same noise, could still be a ground related issue when source attached. Are source and amp definitely on the same circuit currently? Both plugged into same outlet would mean yes. OTherwise, even if different outlets in same room, they still may not be.
mikirob
950 posts
 
Smrex13,
Concur with Brownsfan. Sorry the Emotiva didn't work for you. I'm sure you will get this resolved. Something weird is truly going on. Good luck and keep us posted. I'm positive Israel Blume will do his utmost to help. Best.
jesusa0
149 posts
 
Have you powered on the amp with no loudspeakers connected?
More to discover