Recent sound deterioration shrillness, ringing

I'm not sure about newer Icepower but older modules, including one in my Rowland 102, have this problem. It is because of usage of single supply while reversing direction of the speaker using 4 Mosfet (switches) bridge. That way, half of supply voltage appears on both speaker wires. This supply voltage can be as high as 80V in some modules. There are types of class D modules, like Hypex, that use dual supply with one speaker wire fixed at GND. Channel Island used such modules. If you have any DC voltmeter measure voltage (without the music) from one of speaker wires to chassis or GND of input connector on your sub.

First, it would appear that all of the above is much more important than what I am about offer; some have claimed using a simple zobel network on the speaker cable posts have alleviated the negative descriptions you have outlined.

Thanks, Kijanki, even though I only sort of understand your explanation as it might apply to my situation your reference to switching inspired me, for some reason to look look at my interconnects again as possible culprits. This may be because, being a new user of XLR cabling, phase issues have been in my thinking. Now, I realize that, even though connections in and out of the equalizer are balanced, because connections to from the preamp to the EQ and from the EQ to the amplifier, are through RCA adapters, balanced signals are not being delivered. Anyway, because I tried everything else and determined that the problem had to be between the preamp and the equalizer somewhere, I decided to check the interconnects.

I removed them from the system to check for simple continuity and found something that can only called strange. Although the RCA cabling all checked out, when checking the resistance between the pins on the XLR's I found a VERY low resistance reading between 2 of the pins on one of them. In checking between the same pins on the other cables there is no evidence of even the slightest continuity. This seems impossible; in my understanding and experience, there is either a short or not, not just sort of a short.

Anyway, I just happened to have an extra XLR cable which I installed and everything sounds great again. I went one step further and reinstalled the one with the anomaly and the crummy sound returned. So...I found the problem but am totally baffled. It even crossed my mind that there might be an impedance issue but the voltage applied to the cable by the meter is DC and because this anomaly didn't present in any of the other cables, this could not be the issue.

What I found here seems so unlikely or even impossible, I'm keeping the cable for others to evaluate. BTW, the cable is relatively new showing no damage of any kind.