VPI MOTOR PULLEY ??

HI This is Bob from Bob's Devices.  I don't remember getting an email recently about a pulley, but typically I only need a photo to make sure you get the right part.  VPI is not standard on their parts, even on the same table.  If someone emails or calls, I try to be as responsive as possible.

Forgot to add that Mat has said they don't offer parts direct anymore since it would compete with the dealers.  Not sure if this is a perceived problem or one that the dealers complained about.  Contacting VPI can be a bit of challenge, they do answer the phone but only on select days, I believe it is Tuesday, Wednesday, and  Thursday.  E-mail can also be a challenge, they do answer but are a bit irregular.  The forum is the best bet.  VPI has been very successful the last few years and the extra work makes it harder to get ahold of them.

info@vpiindustries.com

I went out today and bought a metal turning lathe so I can make my own pulley.......It seem that if you don't want to spend your life trying to contact somebody that doesn't want to be contacted, then you might figure out how to do it yourself.....Its given me another viewpoint on some businesses like VPI and PRO-AC ......Its OK to buy a 1000.00 turntable but don't trouble them with the small stuff.......I will make my own out of brass and skip the plastic VPI ones......  Will

autospec, let us know how that exercise turns out.  Seems a bit extreme to go that far.  Sure hope you have experience on a lathe, not an easy task for the uninitiated.