Lyra Atlas experiences


A few years ago, I invested in a Lyra Atlas cartridge / pickup. I have moved up, from Lyra Clavis in the early 2000s and Lyra Titan i later. The Atlas was expensive, but I have not looked back. Yet I wonder, can something more be done, to optimize the Atlas, in my system, and others. How can this remarkable pickup run its best. What are the best phono preamp and system matches. Should the system be rearranged. Have anyone done mods or DIYs to their systems to get the "reception" right? What happened? Comments welcome. You dont need to own a Lyra Atlas but you should have heard it, to join this discussion. Comments from the folks at Lyra are extra welcome - what is your experience.
Oystein
o_holter
Using a fozgometer to align azimuth seemed reasonable until I discovered that:
  • It needs new batteries
  • It has to be calibrated
  • It costs $300
  • It is a box consisting of a meter, analog difference calculation and a couple of idiot lights
  • Its output still must be interpreted (See the experience of other writers who have reported "thumbs up" from the device when their vertical angle was anywhere between 7 and 15 degrees, clearly not correct)
I will and have paid five-figure sums to purchase gear (even cables) that make an audible difference, when there's no alternative.  Since I am not an electrical engineer nor do I wish to build my own gear, there IS no alternative.  But this is a case where better alternatives exist.  Had they priced fozgometer at $50, it might be worth trying.  But this is an egregious example of pawning off an overpriced gizmo to the ignorant.

If one is going to make this adjustment using some instrument, it seems to me that instrument should be capable of delivering all the relevant information.  A decent and well reviewed digital oscilloscope is available for $400.  Or, the Adjust+ software is in the same ballpark, and it will enable deeper understanding of the task you're performing.  Both methods require learning and patience.  It's not beyond the ability of most audiophiles to do so, and we will be better informed for it.  I recommend reading Andre Jennings' article in The Absolute Sound titled "Setting up a Phono Cartridge".
o_holter: The Lyra Atlas has never actually skipped a track in my experience.  The mistracking to which I refer is a mild "breakup" on hot recordings of percussion, and piano is a good example.  It doesn't only happen on one LP.  I have heard it on a brand-new Music Matters reissue of a Blue Note, but I didn't write down the specific LP number.  I have also heard it on London CS 6996, Radu Lupu playing Schubert's Piano Sonata No. 5, where the breakup happens on side 2, last track, in the left channel.  It's rare, but disturbing when it happens.

I'll check all the parameters that stringreen recommends and report back when I've solved it.  Thanks to all.
Nandric...My wife was a lawyer (lost her about 12 years ago to a failed heart transplant that was done by the famous Dr. Oz....a much nicer guy in person than on television...we used to have dinner with the Oz's...his liscense plate was "Wizard" ((which I think was kool))  )  ...not much rubbed off on me.



Drastic....Personally I like the Foz. Yes it is very sensitive to voltage, consequently I use a new battery once, and then keep it for my smoke alarms. I’ve used mine 5 or 6 times, and think its easy and accurate...love the idiot lights ...... keeps the guessing at a minimum
Drastic....  Regarding the hot pressings that put down your Lyra..... I'm sure you double and triple checked all your adjusting parameters and the stylus itself.  If it isn't long in the toothe....if it were mine, I'd send it back to Lyra for an inspection/evaluation.  I would think they would do that no cost.....but....