I use the Phoenix Falcon/Roadrunner combo with the Rega 24v motor on a custom diy ’table, works great. Far better then the VPI units. Just make sure you have enough clearance between the platter and plinth for the sensor and magnet. I do wish Phoenix would make the combo available in a single 1U rackmount chassis though..
VPI SDS/ADS PSU with Rega Turntable?
Has anyone tried using a VPI speed controller / power supply such as the new ADS or the older SDS with a Rega TT?
I have a P3 whose motor is getting a bit weak (very slow to start up) and I'm considering finally updating it with the Rega 24V motor. This would make the Rega TT PSU an option now, but considering that Regas are know to run a bit fast, was thinking about getting something that would allow me to fine-tune the speed. Has anyone tried this?
I have a P3 whose motor is getting a bit weak (very slow to start up) and I'm considering finally updating it with the Rega 24V motor. This would make the Rega TT PSU an option now, but considering that Regas are know to run a bit fast, was thinking about getting something that would allow me to fine-tune the speed. Has anyone tried this?
- ...
- 8 posts total
| Post removed |
- 8 posts total