Bi-wires links for speakers ?

the soundstage suddenly became huge the speakers completely disappeared !
There is a substantial boost in the bass much more massive, deaper and tight.
The little bit brightness I had gone completely all is more natural and calm,
Further more my system became more detailed and accurate.

That's simply amazing.  Sounds like a couple of inches of speaker wire makes as much of a difference and improvement as going from a cheap HT receiver to a nice pre and monoblocks.

Yes it’s really amazing I never would believe if I didn’t try it myself.

My 2 lessons here :

1. Throw away immediately the biwiring standard terminals supply with the speakers and get descent Bi-wire cables links.
2. It is very important to have synergy between cables the most easy way to achieve it is by using the same brand and level/series for all the cables in your system  including the bi-wire links should be at least match quality of speaker cable.

1. Throw away immediately the biwiring standard terminals supply with the speakers and get descent Bi-wire cables links.

I don't know that I would recommend this.
Someday you may want to sell those speakers.

@OP-It seems like you have your mind made up. Why bother posting this thread?

How do you figure? He started a thread asking if anyone had heard a difference by replacing the stock jumpers that come with the speakers with quality aftermarket jumpers. He got a couple responses to his original question. Granted, he got more responses touting bi-wiring, which is NOT what he was asking about.

I understand that is how things go on these forums. Folks come here asking about their amplifier, and others will recommend that they get new speakers instead. That doesn't mean that his original question was worthless, or went unanswered.

He asked a direct question, filtered out all of the off-topic answers, then tried on his own, and he is happy with the change in sound in his system.
That would seem to be what the forums are for.

@OP. Still a skeptic.  That's way beyond anything I heard from trying out bi-wiring or passive bi-amping (with the same or similar amps).

But, it's been a long time since I monkeyed with it and with lesser gear, then.  And I have no reason to believe you are clinically delusional or making it up, so, I am going to try it, too, at least with a couple of the stock bar jumpers, for what little effort it will require.  It will be with stranded 12 gauge OFC with bare ends.  One might argue that whatever would make the stock bar jumpers so awful should be the same or similar to what should happen in all but perhaps the "best" spades or bananas (heck, even the binding posts on either end), if only on a slightly large scale.

Odd though, which manufacturers opt to use the bar jumpers and even on low-to-mid-five figure speakers...where, seemingly, attention was given to much less obvious or visible details, including internal wiring.

Awesome though, at least for you and your setup, you found a minor tweak that made a difference and that you are happy with!

My dealer was suprise too from this huge impact I really didn’t execpt it at all neither do him but that’s what happened.maybe the jumpers supplied with the speakers are very poor quality, or maybe because all my cables now are from the same brand  and the same series this allowing better signal transmission from the amplification to the speakers . I really don’t know what happened.