LTA - MZ2 Driving solid state amps.


Hello All,

I want to get a new pre and I have narrowed it down to the LTA  MZ2 and ps audio bhk, with the mz2'being the one I probably will try.Both of these have built in headphone amps which I would occasionally like.

I would like any feedback on both preamps related to the pairing with solid state amps of any kind.

Kenny.
kdude66
@pryso - Thanks Tim and Yes that should have been a Parasound JC3+ phono stage.
Lance,
That's a interesting comparison,may just want to stick with the volume control on the Sonica unless this system needs more than 1 input.

I'll need a preamp with 3 inputs in my main system,I have used the volume control on my direct stream and It's a good one though.

I do know that sometimes we do tend to over complicate our systems and sometimes simpler maybe better and on the other hand if we didn't try multiple combo's we would never know or experience changes for the better.Just a part of the hobby.

Kenny.
Kenny,
i did get my MZ2 with 3 inputs and gave up the speaker terminals for a second set of outputs in case I wanted to connect powered subs. My Micro ZOTL already has speaker terminals anyway.

update on the AHB2: I ran it in all weekend and I now after some critical listening I think it is superior to the Job 225 in almost every way and the bass is every bit as good or better. I'm hearing more on recordings in this system than I've heard before, micro details are being revealed. I guess it's the low noise floor.
Lance,

I didn't know LTA could configure their MZ2 with 2 sets of preamp outputs instead of speaker output terminals,I'm sure there is not very much room on the back the unit is only 9 inches wide.

The AHB2 has such astonishing low noise and or distortion specs. I would suspect none the less on micro detail retrieval and probably convey's the nature warmth and nuances on each individual recording without adding much of anything other than gain.
It's good to hear that the bass,with some breakin time has equaled or is better than the Job,I thought the Job had really good bass when I used one.

Just proves once again that most components need some time on them to settle in and really show their true character.

Kenny.
Another feature of the MZ2 is the ability to change the output tubes heater voltage from either  6volt to 12volt,so either 12sn7 or 6sn7 tubes can be used.

I already have a good collection of nos and new production 6sn7's to try but I see the prices on some of the best tubes are very expensive,they must be getting more scarce then I thought.I haven't bought any tubes in 6 or 7 yrs I haven't had a need to.

Has anybody had good luck finding really good 12sn7's and where did you buy them.

I know Lance mentioned he is using 1940's Tung Sol ovals,black glass.

Kenny.