1. Home
  2. tech-talk
  3. 130828-75330

Why are my crossovers different

So the schematic on my m1 crossovers says that c2 circuit (midrange circuit) should total 26.7uF
The crossover that I just recapped had the c2 circuit at 25.7uF.
The crossover I’m working on right now has the c2 circcuit at 28.1.
It does not appear these have not been tampered with since the factory.
So the question is should I make the second c2 circuit match the 25.7 of the first or should I put it back the way it was at 28.1

I could make the second one a 26. 8uF. I accidentally damaged a 1.3uF that was in the 28.1. So I’m debating on whether I should replace it or leave it out.

Your input would be appreciated
idahifi
idahifi OP
100 posts
 
Here's something kinda interesting,  the 4.7 on my buddy's pair look identical in shape and color to the 6.8 that's in place of the 4.7 on mine.  It sounds stupid but I'm wondering if the gut putting it together thought it was a 4.7 but it was actually  a 6.8
idahifi OP
100 posts
 
Also I can't measure all the original caps because the last one broke, it was damaged when I removed it.  It was the one with the stripes which came out as 1.5uF  I think 
idahifi OP
100 posts
 
I think i will buy  the meter and test the old caps, excerpt for the broken one and see if there all as labelled,  then I can get an idea where it was set at. Maybe the factory had this one a pinch above the spec 
erik_squires
5,268 posts
 
You don't need to measure each cap separately. Measure the bundle. That's the whole point.

Best,

E
idahifi OP
100 posts
 
Stupid question, but can you do that on the board are no. I realize that it's the bundle that has be measured I just thought I would just add the values 

More to discover