1. Home
  2. analog
  3. 1325551242

Eminent Technology ET-2 Tonearm Owners


Where are you? What mods have you done ?

I have been using these ET2's for over 9 years now.
I am still figuring them out and learning from them. They can be modified in so many ways. Bruce Thigpen laid down the GENIUS behind this tonearm over 20 years ago. Some of you have owned them for over 20 years !

Tell us your secrets.

New owners – what questions do you have ?

We may even be able to coax Bruce to post here. :^)

There are so many modifications that can be done.

Dressing of the wire with this arm is critical to get optimum sonics along with proper counterweight setup.

Let me start it off.

Please tell us what you have found to be the best wire for the ET-2 tonearm ? One that is pliable/doesn’t crink or curl. Whats the best way of dressing it so it doesn’t impact the arm. Through the spindle - Over the manifold - Below manifold ? What have you come up with ?
ct0517
dlcockrum's avatar
dlcockrum
2,105 posts
 
Brad, I assume you know that you need to remove the manifold from the housing in order to thoroughly clean it. Gentle but firm thumb pressure on one end of the manifold while securely holding the housing should break it loose. Don’t strike or pry the end of the manifold with anything, just keeping working with it until it starts to budge.

Check back with issues/questions and once you are done with this as there are a few things that are very critical to proper setup that are not completely detailed in the manual. There are several here that are experts and we will help.

You can view my setup on my Virtual System page for reference. Click on "Toggle details" tab for explanation.
https://systems.audiogon.com/systems/3778

Dave

xbart
10 posts
 
Dave,
I tried just using a toothbush and IPA to clean the manifold as per the manual instructions and it still is not working. So that was going to be the next step. I need to find pipe cleaners to clean out all the holes.
   -Brad
dlcockrum's avatar
dlcockrum
2,105 posts
 
Right. :)
dlcockrum's avatar
dlcockrum
2,105 posts
 
Hey Brad,

Also check for obstructions in the airline and nipple feeding the body of the manifold housing.

Dave
xbart
10 posts
 
Hey Brad,

Also check for obstructions in the airline and nipple feeding the body of the manifold housing.

Dave

Dave,
I made a little more progress, it turned out to be an issue with the pump.
After taking the pump apart I found one of the two magnets had come loose from the arm and it was only doing half duty.
I got the pump fixed and I now have good pressure!
-Brad
More to discover