2. speakers
  3. 132141-68240

Looking for suggestions for a new (to me) pair of high efficiency monitors

Hi,

I’m looking to change out my Legacy Studio HD monitors for something more efficient. The Legacy’s are fine speakers and have served me well, but you all know the drill—time to try something new for the fun of it after several years..

I presently run a Bob Latino VTA ST120 amp. Not a lot of power, but nice sound for not a lot of $$.

No preamp, Mac-mini running Audivana out to my Bryston DAC, which puts out plenty of signal directly into the VTA 120 to drive to full power.

The Legacy’s are rated at 93 dB at 4ohms I believe—interested in getting opinions for alternative high efficiency and detailed monitors. Lost a fair amount of upper freq hearing over the years, in fact I have to wear hearing aids that help hear above 7khz, so mellow mid- and treble doesn’t do it for me. Even so largely listen to acoustic jazz, vocals and lately a smattering of opera. Rarely rock or full range orchestral. 

Thanks in advance!
jsl1234
willemj
1,036 posts
 
Could you explain why the e.g. 2.0 V out of a source becomes a different kind of 2.0 V when it leaves the pre amp?
I agree that anaemic tube amps are never a good idea. However, this room is only 10x12 feet. I use a 2x100 watt rms at 8 Ohm Quad 405-2 into my P3ESRs (i.e. some 130 watt into their 6 Ohm), in an 18 sq m room, and that is fine. It will not bring down the walls, but no small speaker ever will.
audioconnection
1,015 posts
 

((( I use a 2x100 watt rms at 8 Ohm Quad 405-2 into my P3ESRs (i.e. some 130 watt into their 6 Ohm), in an 18 sq m room, and that is fine. It will not bring down the walls, but no small speaker ever will.)))

 That's a fine match with Quad SS agree
  its the tube amps that lays down with the small Harbeths

((Could you explain why the e.g. 2.0 V out of a source becomes a different kind of 2.0 V when it leaves the pre amp?))


 For sure
  A 50 cent integrated circuit PC add in a microprocessor with a compromised power supply sounds more like the screaming weasel
  vs a real Preamp
  Quicksilver line stage with a 12 AT7 real power supply and much better Volume control wins the hart of the music lover every time.
 Do the experiment
 
  Cheers ,
 JohnnyR
willland's avatar
willland
750 posts
 
http://images.klipsch.com/RB81IIcutsheet_635042118979170000.pdf

"Not to disparage low cost speakers but always thought of this line as mass market HT stuff? How do they sound compared to traditional Klipsch Heritage Series Heresy III?"

Of course the RB-81II's are not going to be able to run with the big Heritage Klipsch(Khorns, La Scalas, Cornwalls, Belles) but they can hold there own against the Heresy models and dig a bit deeper.  Not as refined but pretty darn good for "mass market"  

Below is my response to another thread.

"The RB-81II's are pretty big sounding for "bookshelf" speakers and can be driven pretty well with 60w/ch. Before you pull the trigger on those, look on the used market for a pair of RB-75's. They will command a higher price but you will get real wood veneer, a 1.75" titanium true compression driver, and a solid cabinet at 32lbs each. Though my pair sounded awesome with great low frequency extension(nearing 40Hz) in my room, I did add a nice sub to fill in the bottom."

Bill
More to discover