Tube Preamp


I started the discussion about replacing my Adcom 555. I would now like to move the advice to a tube preamp that has the capability to tie in my signal processor.  I'm using a Parasound Halo A21 power amp... recommended  here ... and my AR 303a speakers that I have had for years. . I would love to keep the number under $1500 if possible,

To preface I like to listen loud and boost the freqs that I like. My Adcom has been labeled not "musical"  Any help much appreciated and thanks!
rsbmwrider
I suggest McIntosh c2600 because I own one and it is amazing!  If you stream and play digital music it has a built in dac that’s ready for even dsd256 when they come out.
Quicksilver Line Stage, no frills.... but no remote.  Excellent tube pre with HT bypass for  $1050
I just installed a Schiit Loki EQ device that sells for only 149 from the Schiit website.  It has four knobs that have a decent click at dead center and are turned left or right to influence the EQ.  Each of the four knobs controls a different EQ range, rather than just the old “bass/treble”.  It is passive, and has a bypass switch to take it off line if desired.  It gets VERY HIGH reviews by users as not molesting the quality of the signal.  I can not determine any negative impacts to soundstage or quality of sound.  Each knob adjust at a very slight EQ level for the first portion of the turn, then gets more aggressive as you turn it more, allowing for very fine tuning.  You simply install in the signal path between your pre and power amp.  This is not the old EQ design, it has the mastery of the latest technology that Schiit has become well known for, at a very good price.  I too have a tube pre-amp, but with no EQ controls, I previously did not like any of this in my system.  Im 65 yrs old and have been running tube equipment since I was 15.  This is the first EQ i have allowed into my system, usually run everthing flat and straight.  Its that good to my ears, and saves me a little money by not always rolling tubes to get the sound I am looking for.  I now get to adjust it for every source and quality of EQ recordings to my taste.  I usually don’t influence it much, but just enough to fine tune each source or specific music.  Read the reviews on the Schiit website or on-line idependant reviews.  Don’t like it?  Send it back.  But I don’t think you will, its that good.
Getting sidetracked from the preamp recommendation, but;
@newf27, I see the Loki is powered by a SMPS wall-wart. Do you think adding a LPS would improve SQ; eg, a lower noise-floor, improved dynamics, soundstage and imaging?
Wall-warts are typically a weak link.