Active crossover advice for 1000hz biamp

The speaker is custom made, so, there is no passive crossover. There are direct connections to the woofer and the horn. The compression driver is 109 db and the woofer is 99db. I was thinking of using an active one because I already have a good amplifier for the bass, EL34 20 watts and Im buying a SET one for the mid-highs something around 2-3watts.

Every horn I have ever worked with required equalization specific to that horn design, and I don't know of any off-the-shelf analogue domain active crossover with such capability. On the other hand, something that does digital signal processing like the DEQX could do the job... but it's hardly trivial to use.

Duke
dealer/manufacturer

Marchand can custom made one for you......is it not too high for crossover point the 1k-1.2k?

Well, I had in mind two cut options. One was around 700hz just above the cut off of the horn(the compression driver only goes down to 500hz) and the other around 1100hz. I rather prefer the 1100hz since I think the 700 is too critical area to cut but I can try.
Alan

Hey, how about a balanced Marchand along with a Manley Massive Passive EQ. Only another $5K, but all analog.