20 foot long speaker cable: is it ok?


Hi guys I'm looking to move my speakers to the long wall of my room, the 14 foot one. In order to do this I'm going to need to acquire a 20 foot pair of speaker cables. I don't (can't) put my amp in the middle.

Based on my research it seems as long as the cable is well made, it shouldn't matter, at least 20 feet or under? I am worried that my sonics will suffer... 
d2girls
Thanks @stereo5 and @shadorne and @almarg as always you 3 are extremely helpful ☺️

Will be ordering a pair of 20 foot 10g Belden pre terminated cables from BlueJeansCable soon.
Post removed 
I may wind up putting my electronics in the middle of my room, in that case I'd need a 12 foot long power cord as my mains (the only one in my room) is off to the side. Thoughts?
It’s fine and just use 10-12 gauge at minimum.  Absolutely no sonic degradation issues.  
I would respectfully disagree with an earlier comment in this thread by a member who appears to have subsequently deleted his post. In addition to the actual experiences with long speaker cables that have been reported by other members, such as Stereo5 above, I’m pretty certain that the Magico speakers used by the author of that deleted post have much lower impedances than the JBLs you will be getting. Most Magico speakers have nominal impedances of 4 ohms, and are closer to 3 ohms at many frequencies. That will significantly increase their sensitivity to cable effects compared to the impedance characteristics of the JBLs.

Regarding power cords, I have used two 13 foot lengths of 12 gauge Signal Cable Magic Power Digital Reference cords to power the two channels of a dual mono 70 watt class A tube amp, with fine results, even though that cord is nominally intended for use with digital components. I chose that model because I wanted the double shielding it provides, in part because the cords are routed near my phono stage.

The 215 watt class AB Kinki Studio solid state amplifier you are getting is a very different animal, of course, but I would still expect that cord to be a reasonable choice. Even if your amp were to be delivering full power on both channels at times, which is very unlikely considering the 94 db sensitivity of the speakers and your relatively small room size, the combined voltage drop of the two current-carrying conductors of a 12 gauge 12 foot power cord would be only around 1/4 of a volt. Probably less than the voltage of the incoming AC fluctuates between different times of the day and night.

Good luck!

-- Al