Phono cable advice.

DIN or RCA it doesn’t matter, it’s just a connector (depends on tonearm original design), but i’ve missed that you have a wireless speakers! Why do you need so many cables if your signal goes to the wireless speakers in the end? Vinyl is analog media, but wireless speakers .... 

Whatever you buy, this is what you want in a phono cable (or in any RCA to RCA cable for that matter, if possible):  Since the cartridge is an inherently balanced device that is treated as single-ended when using RCA to RCA connection into a single-ended phono stage, you want a cable that uses separate but completely equal conductors, one that connected from "hot" to "hot" and one connected from "ground" (on the phono cartridge pins) to "ground" (the outer barrel of the RCA connection).  The shield, if any, is only connected at one end, to chassis ground.
You may say this is obvious, but many RCA cables carry the ground side of the audio signal on the shield; in this case there is only one wire surrounded by a shield.

That’s fundamentally false. A coax cable with a single center conductor can absolutely be used for phono applications. It is properly shielded. Unlike Anticables.

All of the most sensitive instrumentation equipment on Earth at research labs use coax cable. Where even the smallest amount of noise can be a huge issue.

The reason you can make an unshielded cable work in a phono situation is that the cartridge is a pretty low impedance. Its hard for radiated noise to impinge the cable when such a low source impedance is present.
A further advantage is that unshielded cables have lower capacitance per foot, which is really helpful when dealing with the resonance that develops due to the cartridge inductance and the cable capacitance.

Anyone even thinking about using an unshielded phono cable has no business giving advice about anything electrical related.