2. analog
  3. 140184-113812

Turntable got absolutely crushed by CD

Long story short, i've just brought home a VPI classic 1 mounted with a Zu-Denon DL103 on JMW Memorial 10.5 with the appropriate heavier counterweight. Had everything dialed in..perfect azimuth, VTF, overhang, with only a slightly higher than perfect VTA. Levelling checked. All good. 

I did a comparison between the VPI and my Esoteric X03SE and it's not even close. The Esoteric completely crushes the VPI in all regards. The level of treble refinement, air, decay, soundstage depth and width, seperation, tonality, overall coherence is just a simply a league above from what I'm hearing from the VPI. The only area the VPI seems to be better at is bass weight, but not by much. 

I'm honestly quite dumbfounded here. I've always believed that analogue should be superior to digital. I know the Esoteric is a much pricier item but the VPI classic is supposed to be a very good turntable and shouldn't be a slouch either. At this point I feel like I should give up on analogue playback and invest further in digital. 

Has anyone had a similar experience comparing the best of digital to a very good analogue setup?

Equipment:
Esoteric X03SE 
VPI Classic, JMW Memorial 10.5, Zu-DL103
Accuphase C200L
Accuphase P600
AR 90 speakers

Test Record/CD:
Sarah McLachlan - Surfacing (Redbook vs MOV 180g reissue)



chadsort
rodman99999
3,557 posts
 
@chadsort- Too far for me to drive(a bit)!   By, "refreshing", I meant replacing the electrolytic caps, which can be quite numerous in a phono stage. If that wasn’t done, when the rest of the preamp was addressed, the results would be major. No- that won’t offer loading options(sorry), although: loading can be addressed, via internal resistors.
kahlenz
168 posts
 
There are many variables but records will sound different from digital. I don't see the differences between media as being necessarily better or worse, but you can scale the differences between components and systems within a media playback system sub-category (i.e., you can rank MM cartridges, DACS, tonearms, etc.).  I enjoy both digital and analog playback, and choose between the two based on mood, convenience, and, of course, available media.  That I listen to digital most of the time should be no surprise.  But I get a different level of satisfaction listening to vinyl records.
noromance's avatar
noromance
1,780 posts
 
I think you need something more rad but easier.
1. If funds are an issue, get an Ortofon 2M Blue and a Music Hall Mini phono amp ($80 online). If funds are less of an issue, Ortofon Black and a decent tube phono amp or preamp with phono and lose that old preamp.
2. To test and compare, use the same interconnect from phono amp output to amp as for CD to compare.
dentdog's avatar
dentdog
300 posts
 
I'm with Whart as to the necessary requirements for vinyl besting the digital domain. I have a very nice, to me, rig that I enjoy to no end and a nice collection of vinyl. Starting from scratch without a pretty good collection though, not so sure.





uberwaltz's avatar
Ag insider logo xs@2x
uberwaltz
4,946 posts
 
Totally different setup but...
The dl103d on my Denon sounds really flat and lifeless loaded at 100ohm.
It comes to life at 470ohm but best response I have so far is set at 1000ohm. Best overall balance.

I would honestly think a good separate phono stage with lots of options to adjust loading and gain would be the next move of you are going to stick with vinyl.
$400 to $500 should see you into a good used model.
More to discover