1. Home
  2. analog
  3. 142030-1590

Nottingham Spacedeck vs Rega Planar 8 vs Technics SL1200G

Hey Everyone,

An analogue newbie needs your advice.

Firstly I am not looking for any TT recommendations other than these 3.

My system is Devore O96, and the amplification would be either Lyngdorf 3400/Coincident Frankenstein combo or a Shindo pre/amp combo (forthcoming). The phono stage is TBD.

The sound I like is rich, full-bodied, with a good bass (I love percussion, and the double-bass instrument and  Mingus is my fav jazz artist). I am very sensitive to even a hint of brightness. I don't care about the typical audiophile presentation -- gobs of detail and soundstage but no soul.

My music of choice is jazz, vocals and small-scale instrumentals. No rock, no pop, no western classical.

Would love your thoughts on these 3 choices.

Since I am a newbie, easy setup is big win, which might tilt me towards the Rega or Technics, but with Nottingham I have a great dealer support that I would completely miss out on if I went with Technics (no Technics dealer in a 5000 mile radius).

I used to own a Rega RP6, so am familiar with Rega sound, and like it. But my RP6 was bested by my DAC (AMR DP-777) so sold it a few years ago. So I want a TT that will compete with any sub-10000$ DAC.

Looking forward to your thoughts that will help me scratch my analog itch.


essrand
inna
5,245 posts
 
I would consider three MM cartridges - Goldring 1042, Nagaola MP-500 and Audio Note IQ3. Cost - about $500 - $1100.
You also need speed and 'bite' and explosive dynamics for real flamenco, not new age kind of flamenco. Nagaoka and Audio Note might be somewhat more sophisticated and polite.
Perhaps Roxan MMs would be fine as well.
Yeah, Nottingham motor controller wouldn't hurt, especially if the wall current is not good. Also Walker motor controller, maybe even better, about $1600 for either, I guess. I decided not to get it for now, but I have PS Audio conditioner/regenerator to use for the entire system. No, not a full substitute for motor controller but works well.
terry9
931 posts
 
I owned Rega, moved up to NA Mentor (precursor to the Dais). The table is not suspended, so it can take an air bearing tonearm. I use the Trans-Fi, which is surely the best bargain in audio at $1000. Cartridge is a Koetsu.

The 'heavy' kit is worth considering, now or in the future. So is the Wave Mechanic. I gave away my older but well regarded Technics 150 Mk2; not in the same league. Not even close.
chakster's avatar
chakster
2,482 posts
 
Assuming I choose the right cartridge @essrand

The right cartridge is Pickering XSV-3000 (or Stanton 881s) MM with original Stereohedron stylus (one of the best profile ever made) if you don’t want to spend more than $400 to get highly competitive sound up to $800 easily. It’s high compliance MM which is perfect for Technics tonearm. Victor X-1IIe with titanium pipe cantilever and nude elliptical tip is also nice one for under $350, but the Victor X-1II with beryllium cantilever and nude shibata stylus tip is better than all of them, but much more expensive if the condition is like new. Those Victor are mid compliance and great for most of the modern tonearms too. Grace F-14 and LEVEL II are absolutely killer MM cartridges along with the AT-ML180 OFC if the budget is over $1.5k

If you will buy Technics make sure to remove stock rubber mat and replace it with SAEC SS-300 alloy mat with disc stabilizer like Micro Seiki ST-10

This is your ticket to high-end analog 
essrand OP
163 posts
 
I am so far based on your responses leaning towards a spacedeck.

Should I get a ace-space arm or are there better tone-arms for this TT?
agrippa
32 posts
 
Nottingham's tonearms are widely regarded as not being on the same level as their turntables.  Personally I don't particularly like them and chose a Jelco SA-750E instead.  The old line of Jelco arms are excellent performers and still easily available online (eBay seller 2juki is an excellent source), or there's the new line at roughly twice the price.
The (old) Jelcos will perform very well with a large span of cartridge weights and compliances and represent by far the best bang for the buck where tonearms are concerned.  I've not yet heard a new one, so I can't comment on those.
More to discover