HT Speaker Wire Suggestions....?



Which speaker wire would you recommend for a 5.1 HT system? I was considering either WireWorld (Oasis or Solstice 6), or Analysis Plus (Blue or Clear Oval). I've used WW in my audio system years ago, and have used their HDMI cable for the last few years, so I like them. No experience with Analysis Plus. I'm sure either would sound fine. I'm not trying to make this like my audio system.
The speakers are Dali Motif LCR w/ table stands so it needs to be somewhat small and flexible (exposed and under carpet). Speakers need bare wire and importer said 16 gauge. That's smaller then I was considering. I haven't seen the speaker in person yet, but I'm assuming that's just for the bare wire itself in the connector. The jacket just may need to be stripped a bit further then usual. I wanted to use banana at both ends, so just at receiver end now. Easier to manage. The lengths are short; 1M and 2M. I'm doing the speakers in two stages; LCR + Sub, then in a week or two the Dali Fazon SAT for side-surroundlater on and require about 5-6M and run under carpet.

Related gear:

Marantz SR5004
REL R-205 Sub
sakahara
I had Solstice 6 and then ordered Morrow Audio SP1 for all 5 channels. HUGE upgrade. It was so much clearer and more engaging. Much better separation of instruments and voices in movies. They also have a 60 day return policy. Also, the SP1 is so thin it was easily routed to the rear speakers.

Thanks. I'll check it out. What receiver/speakers are you using?

The WW Solstice might actually be too big for my small table stand speakers. Orbit 6 was suggested instead. The MA SP1 being thin is a plus.

Re: Morrow Audio SP1; "Nude termination is not offered on the SP1 due to the delicacy of the wires." My speakers require bare wire.