Should I fix my plasma?

Agree repairing a plasma is an iffy thing.
First, the person doingthe repair probably NEVER saw another one of your model.
It probably cannot be fixed anyway, and you would still be paying for the repair persons time.
Then even if they fix it, it is seven years old.
As another wrote.. just buy a new TV.

If you have a splattering of dead pixels the only fix would be a replacement panel. If it is even available the cost would probably exceed that of 2 new Panasonic VT50's.
Time for a new TV, 1080p, 3d if you care, digital tuner, lower energy consumpsion, latest technology and all new parts. Fixing a 7 year old TV leaves you with a new part and a bunch of 7 year old parts doomed to fail.
Just my advice.

Agreed. Don't throw good money after bad...

Get a new TV and and upgrade in the process. Get better picture quality, probably lower power consumption and a "reset" of the clock ticking on all of the remaining components in the old TV.

When it comes to flat screen TVs, buy as cheap as you can, consistent with a good picture. I got my Panasonic 42" plasma this year, and will be surprised if it lasts five years. Great viewing experience. $398 at walmart.

Sorry to hear about your problem. Been there myself.

If you know electronics and have a good multi-meter, you may be able to isolate what board is causing the problem. Once properly diagnosed, recycled replacement boards are relatively cheap from various sites on the internet. With a little luck and help from a friend, I was able to replace the power supply board on my 2005 Pioneer Plasma for under $80. It as good as new and I hope to get another 5-7 years or so out it. I had an estimate of $359!

Here lies the problem with modern AV electronics, especially flat panels. Unless you can fix yourself, its always better to buy with replacement new. In my case a 50" 720p plasma was $359 to repaiir or spend $500 on a new 50" 1080p plasma. No brainer.

If you do go new, check your local craigslist for scrappers that search out broken flat panels. They do this to pull the boards and resell them to DIY'ers. Often they will pick up and give you a few bucks too. Good luck.