2. digital
  3. 1124942256

Behringer DEQ2496 HELP

After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
ecruz
402 posts
 
Drubin-
Good point, I didn't even think of that. I have Vandersteen 2ce's and they are suppose to go down to about 28hz.
eldartford
4,262 posts
 
Ecruz...
1. Auto EQ works fine below 80 Hz (regardless of what the manual says).
2. Don't try to get flat response any lower than what your speaker is capable of. If you do you will mostly screw up higher frequencies.
3. I use the "FAST" setting, and after things have pretty much settled out I go to MID or SLOW. However, I find that FAST doesn't actually bounce around any more than MED or SLOW. If you were trying to do auto EQ while various noisy activities were going on (perhaps during setup for a live show) the SLOW setting would help.
4. The Delta MAX, and the MAX SPAN parameters allow you to constrain how much EQ is applied. I leave these wide open so that the DEQ2496 can do the best it can.
5. I adjust the gain so that the sound (as picked up by the mic, is about 85 dB. Where this puts your system's controls depends on your system.
ecruz
402 posts
 
Eldartford-
Thanks for the response! I think that answers everything. If I have further questions I'll post back.

I can't believe how good everything sounds putting this "active" component in the signal path. I always thought the shortest, most passive path, from source to speakers was always best. One more myth shot down.
ecruz
402 posts
 
One more question.

How do I know when Auto Eq is finished? The manual says you have to stop it. How do I know when to stop it?
warnerwh
537 posts
 
Hit the button next to the "stop Autoeq" when it's lit. There's three pages there so be sure you're on the right page. Page three will let you watch it do it's thing.
More to discover