2. digital
  3. 1124942256

Behringer DEQ2496 HELP

After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
eldartford
4,262 posts
 
I have not used the I/O selection capability, but from what I read in the manual (page 13) you could select either the digital or analog input, so you could accomodate one additional source. Try it.
ecruz
402 posts
 
Twice now, my Behringer has emmitted a LOUD pop and then shows an error on the display. This has only happened when there was no music playing.

My pre-amp is tube, so I turn it off when I'm not listening. I leave the Behringer and my ss amp on continuously. Both times it happened there was nothing else on, TV, DVD player, nothing. My system is on a dedicated circuit and the DEQ is plugged in to a conditioner.

Any ideas?
eldartford
4,262 posts
 
Ecruz...What does the error message say? I never saw one.
I would try removing the line conditioner and see if the problem still occurs.
ecruz
402 posts
 
It says something like "please shutdown and restart, error 7". I'm sure about the "error 7" but I can't remember exactly what the first part says.

I had read somewhere that there were some quality issues with the Behringer, just wondering if this is related? I will contact Behringer directly and see what they say.
eldartford
4,262 posts
 
Ecruz...Seems to me that a "quality issue" would show up all the time. I rather suspect there is some kind of power or ground disturbance that the Behringer is picking up. Sometimes an input wire from a turned-off source can be noisy...noise that goes away when the source is powered up. In my experience this noise has been Hum, but the Behringer A/D could get all confused trying to interpret it as digital data.
More to discover