Behringer DEQ2496 HELP


After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
"Sometimes an input wire from a turned-off source can be noisy...noise that goes away when the source is powered up..."

"I'm guessing that with the preamp off and thus an open circuit to the input, some noise is being picked up on the input causing the problem."

I bet it is something along these lines. I'll keep you posted if there are any further developements.
I just developed a new problem. I installed a Squeezebox, connected via ethernet. Runs great, no problems, until I turn on the Behringer, then there is a loud buzzing. As soon as I unplug the Squeezebox, the buzzing goes away. It doesn't seem to matter where the Squeezebox or the Behringer are plugged in, same conditioner, same outlet, different conditioners, different outlets, if they are both running, there is buzzing. Also doesn't matter if the Squeezebox goes into the pre via anaolg connections or into the Behringer via digital. Both on, buzzing. One or the other on, no buzzing.

Any ideas?
Eldartford-
http://www.slimdevices.com/

The connection doesn't matter. It starts buzzing as soon as the Sqeezebox is plugged in to the outlet, even if it's connected to the pre-amp and not the DEQ.