Behringer DEQ2496 HELP


After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
Ecruz...The Behringer has a "hard bypass"...you can turn its power off, and the signal will pass through it without any analog or digital processing. Try leaving all the wires connected and shutting the Behringer power off and see if the problem goes away.
Ecruz...What if the Squeezebox is turned on and in the room but not connected to the audio system? It apparently radiates a signal, and maybe that interferes with the Behringer.

Why don't you talk to the Squeezebox service people.
If it's not connected to the pre or the Behringer, but it is turned on, there is no buzzing. If it's connected to the pre with the Behringer turned off there's no buzzing. If it's connected to the pre with the BEhringer turned on there is buzzing. Obviously the Behringer is picking up something and sending it to the amp, I just don't know how to isolate and remove it.
Ok guys,
I finally got mine y'day and am trying to get it up and running. I hit auto eq and i see the process going on page 3. The pink noise is playing, but i do not see a db reading on the Behringer. I read where Eldartford set it at 85 db on the Behringer. Where is this measurement?
Also, my levels are hitting the top of the meter on the left hand side. Is this a problem?
When i hit auto eq, i see the circles moving. But some of them are still at +10 to +15 after a couple of minutes in "fast" mode. Is this a problem? Will it eventually get to flat? What setting do i leave it on when i am finished setting the auto eq?
Thanks.
Kale