1. Home
  2. digital
  3. 1124942256

Behringer DEQ2496 HELP

After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
tvad
9,467 posts
 
Perhaps it drives both channels for the measurement. Is that so? (Now it's your turn to be the Behringer expert!)
That's correct.


BTW....why do cheap car stereos systems often sound pretty amazing.....it is actually very simple, two words....Soffit Mounting.
And compression built into the electronics...something the DEQ2496 offers. That's a module I plan to investigate once a few of my balls have dropped. :)
shadorne's avatar
shadorne
7,333 posts
 
Does the DEQ2496 have an expander?

This might interest me given that most CD's are intentionally mastered with 1 to 3 db of added compression compared to the studio mix. Unfortunately a lot more compression is often used (especially on rock) to achieve a "loud" CD, where the artist simply wants it to sound louder than other CD's.
tvad
9,467 posts
 
It does have an expander.

My latest observation is a channel imbalance which favors the left channel by 1-3db with the DEQ enabled. There is no channel imbalance with the tape loop bypassed (DEQ2496 is in the tape loop).
eldartford
4,262 posts
 
Tvad...How do you measure the imbalance? Did you create it by your EQ curve? 3 dB would be a fault condition for the electronics.
tvad
9,467 posts
 

06-21-06: Eldartford
Tvad...How do you measure the imbalance? Did you create it by your EQ curve? 3 dB would be a fault condition for the electronics.
Imbalance is measured by the DEQ2496 meter...measuring both the input and output.

My EQ is in stereo mode, so there should be no difference between left and right.

What do you mean 3db would be a fault condition for the electronics? BTW, the imbalance has been betweeen 3db and 1 db depending on the recording.

I may swap the interconnects to see if the imbalance follows the interconnect swap. It might be traceable to the preamp tape outputs, but only a test will determine this.

I'll also go back into a previous memory preset and check the levels. Obviously, if they're not the same from preset to preset, then it points to pilot error.
More to discover