High Sensitivity Speakers that work best with SS

I`m not surprised the 1 watt SET amp sounded good(within limits). The Daedalus is a good speaker and will reveal the quality of that low power amplifier rather than mask it. I`ve heard them with the Modwright SS amp and the result was pretty good. However every time I`ve listened to them driven by a quality tube amplifier they just were better,more alive,engaging and natural.The tubes seem to bring out the music`s emotion in these speakers to a higher degree.
Regards,

My feeling is that the less than ideal pairing between high efficient speakers
and ss amps is a consequence of the fact that many high power ss amps can't
do the first watt right. That is, high efficiency speakers require a very small
amount of power to sing (e.g. a tenth, a hundredth, etc. of a watt), whereas
most ss amp are simply not designed to do the first watt right, they are
comfortable when putting out more than 1 watt. I hope that Atmasphere can
shed some light on this. I thank you in advance Ralph.

Along the same lines, I always though that the 1st watt amps of Nelson Pass
were called like that because they were designed to do the first watt right.

Finally, as a few other have mentioned already, Avantgarde Acoustic speakers
are known to sing also with ss amps (not with all though).

Best wishes,
Paul

I paired Pass Lab XA 30.5 with Zu Omen Defs (rated at 98dB) and the combination was fantastic. With the 30 Watts from this amp you could easily drive many medium or high efficiency speakers.

Daedalus_audio, it was in Thom-mackis' room that I got to hear and see that. Duke had brought his speakers down the hall and we played them on Thom's M-60s. I pushed the system hard during that audition and found that I could play the system considerably louder, yet the meters on the amps showed that the amps were not working as hard.

Since Duke's speakers were nominally 16 ohms, the meters were more sensitive (should have read higher), yet they were reading lower.

NVP, with all due respect, subsequent Watts don't compromise the previous Watt. While one might argue that matching output devices require more effort, the benefits that extra power capabilities offer in an effort to avoid proximity to clipping is well worth the effort. SS amps don't have the bandwidth concerns that come with extra power output that tube amps have.
I believe Nelson Pass's First Watt amps are basically kitchen table experiments done on an appropriately small scale. His more serious efforts($) for Pass Labs typically provide larger power output.