Dan, my apologies, I should have mentioned my concerns were based mostly on two Teres owners posting on VA. The one owner has subsequently sold his Teres and bought a VPI. The post was not aimed at you.
The said gentlemen had, to my knowledge, no preconceived negative bias toward unipivots/low compliance carts, yet had experienced problems. Since I owned and used (quite successfully I might add) the same arm and cartridge combo one of them had on my VPI, the problem could only be a result of bad setup or an incompatibility with table itself. I have no reason to suspect either gents ability to achieve a good arm/cart setup.
You have somewhat consistently, demonstrated a high degree of negative bias towards certain technologies, unipivots being one. Some people just dont like certain things and I most certainly have no issue with that. I therefore did not consider your personal bias as a reflection of some characteristic of your turntable or cartridge (and still do not).
Regards
Paul
The said gentlemen had, to my knowledge, no preconceived negative bias toward unipivots/low compliance carts, yet had experienced problems. Since I owned and used (quite successfully I might add) the same arm and cartridge combo one of them had on my VPI, the problem could only be a result of bad setup or an incompatibility with table itself. I have no reason to suspect either gents ability to achieve a good arm/cart setup.
You have somewhat consistently, demonstrated a high degree of negative bias towards certain technologies, unipivots being one. Some people just dont like certain things and I most certainly have no issue with that. I therefore did not consider your personal bias as a reflection of some characteristic of your turntable or cartridge (and still do not).
Regards
Paul