2. analog
  3. 1201814427

Best location setup of turntable

I have a pair of Tyler Taylo 7U speakers, Thorens TD145MKii, ClearAudio Microbasic phono preamp, and 55W Chinese built tube amp.
What would be a good (or best) location of the turntable?
Currently it is sitting on the bare wood floor in between an audio rack and the right speaker in my living room (20x25). The distance to the rack is about 3" and to the right speaker is about 10".

I tried to sit the turntable on top of the audio rack, but the vibration is much worse than just let it sitting on the bare floor. I tried to put the turntable on top of a sandbag, but it did not help much to reduce the rambling/distortion (or whatever you call) when the volume goes of 12 o'clock.

Any suggestion?
Would isolator help? What kind isolator would be good (Well under $100)?

Thanks for your opinion in advance.
ihcho
ontjesr
157 posts
 
You mean, it's not on the wall yet??
tgrisham
1,179 posts
 
I learned that two small racks next to each other was better than one tall one. I played test tones as Pryso mentioned and found the place with the lowest volume tones. It turned out to be along a side wall, with spikes through the carpet and pad to the concrete floor. I avoided the wall because traffic from above and behind created vibrations. I also shielded the TT from any direct sound from the speaker by using the second rack and a MDF board. You'll have to experiment and see what works. A combination of spikes, Sorbothane and Herbie's dots are what I use. Have fun, and enjoy!
carter9000
23 posts
 
I am considering relocating my turntable closer to my speakers. Right now it is on the opposite wall, but it is nearly a 40 foot run of speaker cable, so I have to go cheap on the cable (monoprice 12 gage cable). By moving it closer I could use better quality 8 to 10 cable (Kimber - black and gray braided cable).

I have concrete floors and plan on leaving it on a floorstanding rack, since very little if any floor vibration will transfer to the stand...but by moving it closer to the speakers the base may cause more vibration. So it's a trade off, better cable but closer to the speakers for shorter cable run and better quality cable.

What do you all think? What would you do?
tweak1
870 posts
 
check out Machina Dynamic Promethean base. This would allow you to put it back on top of the rack
ihcho's avatar
ihcho OP
329 posts
 
Many good advice.
Thanks.
I thought a pillow cover filled with sand would be as good an isolation device than any other, but I guess I was not right?
Aagin, my living room is wood floor. Among isolation platform (by nimbus or similar), wall mount rack (by Target or similar), and isolation pads, which would be best, per performance/price wise?
More to discover