2. analog
  3. 1205623178

Denon 103r ????

I have made some improvement to my 103r, but am still getting tonal imbalance with this cartridge.
It's too bright and edgy on some recordings!
At times it sounds incredible, excellent imaging and sound stage.
What do I do though to tame down the brightness. Change the tracking force a bit or tracking angle, change the loading, impedence or capacitance. Add more tonearm bearing fluid or remove?
pedrillo
mingles
775 posts
 
I'm looking for comments on this if anyone has info to share. Thanks in advance. -Mark

03-17-08: Mingles
what tools and methods do you use to align your cartridge on your tonearm? I've been using the paper guide that came with my RB-300. Square carts like the 103 are easy to set up. Non-square carts like the Sonata are much more difficult. Would a protractor help align things more accurately?
pauly
456 posts
 
I performed surgery on a standard 103. I'll keep my 103R for comparison until I decide to do the same thing.

A std DL103R is not even close as good as a wood body DL103. I suggest you buy two bodies. You'll want to do the DL103R a few seconds after you hear the wood body DL103.

Another option is to run the cart nude. I believe Anumber sells brass plates that you can epoxy the nude DL onto and mount. I have not tried that, but a few that have tried says it sound quite good also.

Regards
Paul
gadfly's avatar
gadfly
194 posts
 
.

yeah.
I have the wood body on my 103 and plan to use the brass place anumber1 sells for the R.

http://home.comcast.net/%7Eomaille/anumber1/brass.html

I think I will fasten a small, 2mm, piece of wood to the brass to change the tone a bit.

.
mingles
775 posts
 
Is it possible to remove the cartridge from Al's brass plate without damaging it? I'd like to try the plate first, then move on to the wood body.
gadfly's avatar
gadfly
194 posts
 
.

Yes you can and i used super glue. the thing I learned about super glue is that it has a strong bond if you try to pull 'away' but if you twist, that is where super glue will let go.

Scarey though. I put a drop of super glue and ran that for a while. I had to set the plate down, hold the back of the cartridge and just exert pressure and it freed. I had to push though.
More to discover