2. analog
  3. 1207765473

Is the KAB Fluid Damper worth it if...

...that is the only mod you purchase for a technics 1210? My setup will consist of a 3" maple platform with brass footers replacing the existing ones. I really don't think I could do the rewire myself, and I don't really want to send my turntable into KAB. With just the purchase of the damper would this rig be able to get the most out of higher end cartridges?--Cheers
jmoog08
vinylvin
68 posts
 
3/4 " must be the hole size, I thought that was
small, the washer diameter is 2 1/4 ". They are
maybe 1/8 " thick.
vinylvin
68 posts
 
"That must barely fit within the molded edge"

It fits over not in, I thought I got one the fit
inside the hole but these fit over & worked perfect.
It's more like 1/16" thick. It looks nice also. Just
pick out ones that are the same, they don't all have
the same edge. It sounds so much better with the cones.
radioheadokplayer
173 posts
 
so anyone try what vinylvin did to find a threaded cone to perfectly replace the technics tt feet?
johnnyb53
3,490 posts
 
07-04-08: Radioheadokplayer
so anyone try what vinylvin did to find a threaded cone to perfectly replace the technics tt feet?
I also use Dayton brass speaker cones (from Parts Express) to replace the std. M5G feet. They come with exact screw-in replacement size M6 threads. I definitely noticed an improvement when I replaced the Technics feet with the brass cones. But I haven't put the washers in yet. That'll come next when I remember to pick up a set next time I'm in Home Depot.
alex_yakovlev
102 posts
 
Kevin is in my opinion an absolute expert in 1200, and I wholeheartedly stand behind all of his upgrades. Personally, I consider fluid damper and power supply to be the most important ones.
More to discover