Please, any comments ? I am trying to install the VTAF in the RB1000 / Rega P9 and I am facing a lot of problems concerning the tonearm height. Even using a higher spacer between the cartridge and headshell, adjusting the lift mechanism to the lowest level, the tonearm is still positive in around 3mm.
Actually the spacers supplied by Pete are supposed to be installed only on the rear of the cartridge top surface and I am little concerned by that since by adding a spacer only in one are of the top cartridge can alter the stylus angle. As a result, I am still trying to use a spacer right now that covers all top cartridge surface.
The VTAF adds 11mm to the total tonearm height which seems to high for me. For sure I am in touch with Pete, but any help from somebody that has already used it in a Rega P9 / RB1000 ( or any Rega table with 3 points tonearm ) will be very helpful. I am using the VTAF with the extension supplied by Pete ( in order to avoid to make an addition hole in the plinth ) which add an extra height of around 4mm in the total VTAF heigh, comparing to the "normal" VTAF.
Thank you,
Actually the spacers supplied by Pete are supposed to be installed only on the rear of the cartridge top surface and I am little concerned by that since by adding a spacer only in one are of the top cartridge can alter the stylus angle. As a result, I am still trying to use a spacer right now that covers all top cartridge surface.
The VTAF adds 11mm to the total tonearm height which seems to high for me. For sure I am in touch with Pete, but any help from somebody that has already used it in a Rega P9 / RB1000 ( or any Rega table with 3 points tonearm ) will be very helpful. I am using the VTAF with the extension supplied by Pete ( in order to avoid to make an addition hole in the plinth ) which add an extra height of around 4mm in the total VTAF heigh, comparing to the "normal" VTAF.
Thank you,