MM vs MC


What are the differences between MM and MC?

Which is "BETTER"?

What are the pro's and con's?

Thanks

Kev
128x128thegoldenear
Dear Kev: Here you can find some interesting information on the subject: http://forum.audiogon.com/cgi-bin/fr.pl?eanlg&1200430667

which is better?, this is a complex answer because is system/ears/know-how/music-sound priorities dependent.

You can read ( for example ) in that link a post of an owner of these cartridges ( MM/MC ): where the Nagaoka MP-50 ( 400.00 ) performs better that the Allaerts MC2 Finish ( 8,000.00 ).

This experience can tell me that the MM are better than the MC ones?, certainly not.

There are some MM cartridges that are really great and can/could put on shame top MC cartridges for a lot lot less money.
Both designs have its own advantages/disadvantages, between other things: the execution/build quality of the design, set-up, price, tonearm/cartridge matching, own music priorities and whole system quality performance have a definitive influential on every one choice.

Regards and enjoy the music.
Raul.
It's probably worth distinguishing Moving Iron (MI) vs. Moving Magnet (MM) as well. MI usually has the same output and capacitive considerations as MM, but its design allows for less weight at the other end of the cantilever. Also, since there are some advantages (inductance?) to low output owing to fewer coil winds, Grado, that great purveyor of MI carts, makes some low output (0.5mV) versions of their premium wood-bodied cartridges.

Also, there are some other things that can be done to improve the responsiveness of MM. The use of neodymium magnets could dramatically reduce the moving mass. The Audio Technica AT150MLX uses two tiny magnets in a V configuration for improved stereo separation and 6-nines copper throughout. I'm not sure if it uses neodymium magnets, but it's very transparent, lively, and quick, especially for an MM, and especially for a cart that can be had for $250 shipped.

There are plenty of good cartridges from CartridgeMan and SoundSmith, and some respectable ones from ClearAudio, Rega, and others that keep MM designs competitive at least up to the $1.5K range. Their higher output can make for a lower overall S/N ratio when the entire signal chain is taken into account. There's less noise at the speaker end from a 5mV source than a 0.5mV source.
Another consideration is the output of your phono stage. This would indeed dictate what cartridge you should buy.
Steve