2. analog
  3. 1237056792

Replacement Feet For Rega Planar 3

I am interested in hearing from some of you that have replaced the stock Rega feet with something else. I know there are those that say leave it alone. That is fine, but I am interested in hearing from those that have done it. I really would like something that can screw in to where the Rega feet had been. I want to attach them, not just lay the table on top of them. Opinions? Thank you!
zoltarcat
stanwal's avatar
stanwal
3,147 posts
 
The Star Sound Audio threaded brass cones made a big difference on my Scoutmaster, you could look at them.
johnnyb53
3,490 posts
 
This is a very low-risk one to try: get a set of four Vibrapod cones and four vibrapod feet. You'd have to weigh your turntable to determine if you should use Vibrapod 1 (use 4 for an 8-to 12-lb. component) or Vibrapod 2 (use 4 for 16-30 lb. component). Remove the Rega feet and rest the foot sockets on the balls of the Vibrapod cones. Then place the cones on top of the Vibrapod Isolators. It takes a few hours for the Vibrapod materials to deflect to their optimum performance.

See what you think; I think you'll get a little more clarity and inner detail, better soundstage, etc. and if you don't, you have 30 days to send them back for a full refund minus return shipping, which should be minimal given how small and light they are.
lindisfarne
507 posts
 
Not sure you can remove the Rega feet.
More to discover