1. Home
  2. analog
  3. 1242943783

DIN to RCA adapter

I want to burn-in a phono cable by using it as a SE IC between my CDp and preamp.

The phono cable I want to burn-in terminates with a 5 pin female DIN at one end and a pair of male RCAs at the other.  I have been told that I can build a home grown cheapo adapter using zip cord and a Radio Shack DIN.

So, I would need an inexpensive cable that terminates at one end in a pair of male RCAs.  I can cut-off the other end (whatever it is) and solder on a male 5 pin DIN.  
 
Does it matter which of the 5 pins on the DIN are soldered to which wire coming from the RCAs?  Most "zip cord" has just two wires, so I would be soldering at two of the five pins.

Any help (or suggestions) would be appreciated.

Brent
flyfish2002
albertporter's avatar
albertporter
4,927 posts
 
Brent The color code Thom supplied is all you need, the instructions I gave will do the job and you can walk away and let your CD or DVD do the work.

Cartridge can stay in the head shell, but use common sense and patience when you hook up, CD signal should not go into your cartridge.

Using this method, you break in cartridge clips, headshell leads, tonearm wire, DIN and tonearm cable all in one move.
flyfish2002's avatar
flyfish2002 OP
94 posts
 
Thanks for all the very helpful advice. Since I don't have the connectors Thom used, two additional questions re: the alligator clips:

1. My home grown IC will have two alligator clips at one end and two male RCAs at the other. Do I combine the two right leads (red and green), clipping them together using the right alligator clip and then do the same for the two left leads (blue and white)?

2. When I connect the alligator clips, I don't want to crush the tone arm wire terminations - any thoughts here?

Thanks.

Brent
rauliruegas
9,123 posts
 
Dear Brent: I don't know which tonearm cable you own and what cartridge. Trying several and differents tonearm cables ones of them were RCA to RCA where is very easy to make what you want and I did with out almost no advantage against a non-burn cable after 40-50 hours of use maybe a little more.

If I was you I will run that tonearm cable in normal use and don't take all those effort that you need to burm-in to obtain almost nothing because the cable after those normal play hours will be on target.

Anyway your call.

Regards and enjoy the music.
Raul.
flyfish2002's avatar
flyfish2002 OP
94 posts
 
Raul,

Thanks for the post. The tone arm is a Graham 1.5TC, the cartridge is a Clearaudio Stradivari and the phono cable is Silver Audio's Silver Breeze DIN to RCA.

Brent
dgarretson
2,394 posts
 
Brent, These pins will mate directly to the cartridge clips. In DIY I use high-quality gold-over-copper male/female Bulgin pins in various sizes for intrachassis connections.

http://www.alliedelec.com/Search/ProductDetail.aspx?SKU=565-0058&MPN=SA3350/1
More to discover