Micro Max 282 vs. Exclusive EA-10

Logenn, welcome to the fascinating world of Nihon`s best turntable manufacturer ever! Also the Coralstone is a wonderful cartridge and your Max is a perfect match.
Regarding the silver cables: It is nearly not possible to get Kondo silver litz for tonearm rewiring, the same with Crystal Cable. Both are excellent cables. In case of the Kondo it is very difficult to work with them cause every single filament is covered with thin plastic you have to unsolder. Usually it should be done by Kondo themselves or by some special dealers having the Kondo machine.

After rewiring you should also use silver wires in your headshell (Ikeda maybe). My best experience was with a SAEC 506/30 which was rewired from the cart`s pins (headshell) to the SUT (1,2 meters). No interfaces at all.

Enjoy this world. It is different!!! glad having you on board.

best & fun only - Thuchan

Thuchan, Dertonarm,

I have a MAX282 and would like to rewire it. I have all 3 armwands (AU, SC and SM). IS it difficult? Do you know someone who can do it? Thnks

Dear Nikola, headshell leads should - as well as the phono-cable - be silver as well to preserve the minute details. In any case - it is a chain that transports a signal which gets spoiled, altered and diminished during its path through several terminals, cables, passive and active components, solder joints, networks etc. Every single step/part in this chain which you alter to transport the signal with less alternation, will sonically pay off.
Especially here in the very beginning of the path, where the signal from a LOMC is a fraction of a millivolt in voltage and similar low current.
To use a conductor with as high as possible conductivity is only logic in my point of view.
Hand -in-hand with this rewiring goes cleaning of the solder points and re-soldering with lead free 10% silver solder.
Cheers,
D.

Dear Logenn, IMHO the Ikeda silver inner wire is the best of all worlds. Very flexible, very pure, pretty heavy gauge and superb insulation which can (if one knows how) be stripped without the slightest harm to the conductor.
I use Ikeda inner wire since 20 years now and had nothing but the very best results with it.
Most of the great tonearms from the past to suffer from poor inner wiring.
If you look at several top-flight-tonearms of today, you see that many of them sport inner wiring of high caliber and sometimes even prime trademark.
It certainly is an essential part of their performance.
In tonearm we are dealing with the lowest and smallest (read: most fragile) incarnation of the audio signal.
Careful inner wiring with highest conductivity metal is kind of "clearing the alley for the sonic parade".
Cheers,
D.

Hi Ddriveman,

I give all my arms for rewiring to Dertonarm, it`s not cheap but you can trust the quality for years. I always go for new DIN-connectors, the old ones you may send to the moon. Some guys use them again due to "vintage& original design". They never anticipate you open up the arm again...

best & fun only - Thuchan