Rega 700 rewire

As you are mistaken about my skills, Reb, re DIY soldering and wiring, I am having Galen Carol in San Antonio, do a re-wire, with Cardas/Incognito as he has done tonearms for me before and is very good. I have the ability to take TT's apart, and even get them back together occasionally, but I draw the line at wiring. I was tempted to trade up to the P9, but it is very expensive and I can always do it after I have spent some time enjoying the work I have recently done, platter, counter weight, now the wiring, Rega wall mount. Now I only need to find the best cart, for this TT and the EAR 834P Phono Pre. I am about to take some time and advice from Nandric and go back and catch up on the MM/MC revolucion. I own an old Supex 901 Super and think it's great, but I am always looking for somethin better and improvement, I just don't seem to always get it by opening up my wallet.
Thanks to all of you.

Raul, I have been reading some of your MM/MC threads and you obviously have quite a bit of experience. I have using the buy what I saw and what I could afford at the moment, method of building a system. Based on limited knowledge, being a novice, although I have been playing with hi-fi for over thirty years. My system, currently is, Mac 275 tube amp, the modern version, Mac 220-c tube pre, EAR 834P Preamp, Adcom GFA-555 solid state Amp, the tweaked Rega P5, as well as a VPI TT, intro model ,with numerous mods, including Scout platter, upgraded Rega 300 arm, upgraded sub platter and arm board, all acrylic and upgraded bearing. I am using B&W 804 speakers and my music runs from Jazz and Classical to classic rock. I don't have the money to make any significant purchases right now, but I am still looking for the ideal cartridge for my Rega P5, 700 arm, taking into consideration the rewiring and the EAR phono pre. Incidentally I use the Mac tube 275, to run the high end and the Adcom solid state 200 wpc, for the woofers in my bi wired B&W's. Any thoughts? Sorry for the long post but I thought since I am trying to learn rather than using the hit and miss approach I have been using I should get it all out there.
Thanks again

Hi Reb, While I am trying to 'get' those mods as cheap as
possible you are persistent in the opposite. Why should one
buy an expensive tonearm and then rewire the thing?
For the Rega 300 this makes sense in (co)relation to the price. Roy Gandy gets +/- 50% of the selling price so he must be economical somewhere. He is maybe an stubborn guy but it is totaly different matter to suppose or suggest that he is an incompetent designer. Those Regas are an immense success you know. In particular the 300/250 versions.
Regards,

Thanks again for all your input, I now have another potential issue. I have decided to try the Grado Statement Master, for my Rega. I had a couple of suggestions about the Grado and I have always liked them in the past. I now have been told that there is a potential hum issue with the Grado/Rega TT combo. Due to unshielded motor housing in the Rega. Is anyone familiar with this and if so, what are some possible solututions, other than selling the Grado as soon as it arrives.
Thanks again in advance. Jerry

Can't advise you re the hum issue, but be carefull re the Grado's output and the EAR. If your Grado's output is .5mv, you will have a problem with the EAR's 500 ohm input impedance in MC mode. If you have the 5mv version of the cartridge you are OK, in MM mode.