Dynavector 17D3 hitting clamp on VPI Scout

The Karat has a tiny cantilever.. true, delicate not true. The cart has two side ribs on the body that the stylus sits between and they do a good job of protecting the stylus from sidways movement when the stylus in on the Lp surface.
I own a Dynavector Karat and the short stiff cantilever is quite strong. (and a similar Ruby 23)
Now my Benz Glider.. WHOah!! like a leg sticking out in a crowded restaurant.

Thanks for the replies, folks. Lewm, I'm not positive, but I suspect that the problem will occur with most if not all records on my system. I only played a few before I realized what was happening, and since then I've either lifted the tonearm before the run-out grooves or played records without the clamp. I don't want to do any experiments that might cause damage. I checked the records I played, though, and the clamp doesn't extend over the run-out grooves. I checked a number of records by moving the tonearm by hand to the end of the playing surface (without actually playing the record) and it looks like the edge of the cart would impact the clamp in every case. The problem seems to be that the cart is wide enough that its sides extend beyond the playing surface.

I like the idea of grinding down the clamp, although I don't think it's going to work. I looked at the bottom of the thing and discovered that the surface is only about a quarter of an inch wide. If I ground it enough to give room for the cart I might destroy it.

I'd be open to using another clamp or weight or something. I'm very new to this so I'm not really sure what the options are. It looks like most of the clamps out there are for specific turntables.

Thanks for helping out a newbie!

Another newbie question.... do turntable mats perform some of the same functions as a clamp? Would a mat be a solution in my case?

I found the same problem with a Michell Engineering clamp. The Karat 17D3 has a very wide body and it hits at least half the LPs that I've played. I try to lift the tone arm before it hits the clamp but oftentimes I'm just a tad late. I don't think that the slight bending of the cantilever is exerting enough torque on the stylus or generator to do harm in the short term but I've been thinking of shaving the clamp down to avoid potential damage in the long term. The Michell Engineering clamp bell is made of delrin so it'll be easy to grind down but I'm not sure about the resulting aesthetics.

Seems that Dynavector needs to redesign the Karat's dimensions so that it doesn't become a deciding factor in cartridge choice. The 17D3 is such a fine cartridge, I'd hate to think people would avoid it because of this problem.

Tom

Hi, A mat won't solve anything for you. It also requires raising the tonearm, to maintain proper vertical tracking angle and stylus rake angle. I have a Dynavector XX2MKII cartridge, and have not had any problems such as yours. I have used the clamp that came with the table, the Stainless heavy VPI weight, and now a TTW (Turn Table Weights) heavy brass clamp that works very well, and is a joy to look at. I don't recall anyone else having this problem, and there's quite a few Scouts out there using the same cartridge as you are, so I am surprised to hear this. If it's a newer version of the Scout, perhaps they changed the clamp. Try giving VPI a call, and report the problem, I'm sure they can come up with a solution.

Good luck,
Dan