1. Home
  2. analog
  3. 1314542997

Tonearm Choice:SME or Rega?

I am refurbishing a Garrard 301 greased bearing TT but haven't decided on which tonearm to use. I like the classic beauty and design of the SME 3009 and all of the upgrades and options available, but I also have my eye on the Rega RB300. My current cartridge is a Grado Statement Sonata1, but I'll probably put something else on the Garrard when it's done, possibly a Denon 103 or other MC. I can be patient as I haven't built a new plinth yet, but I would like to have the tonearm in hand when I do. Words of advice from anyone with experience in these matters would be greatly appreciated, as well as other tonearm suggestions. So far, the 3009 is at the top of my list, so my budget is under $1000.
heyraz
dekay's avatar
dekay
2,959 posts
 
My 2 cents:

Instead of fixating on the inexpensive Denon (with it's special requirements) look for a tonearm that will work with a wide range of cartridges in your price range.
heyraz OP
177 posts
 
Dekay-I only considered "that" Denon because it always seemed to come up in discussions as though it were a "gold standard cartridge" of sorts. Since that's not such a great concern to me anymore, at least for the moment, I am still looking for a tonearm that will mate well with the Garrard 301 and allow me to use my Grado Sonata. Admittedly having little experience in this matter, it seems VTA adjustment and tonearm height will be a factor given the 301 chassis sits so high above the plinth, (roughly 14mm by my estimate), and the platter even higher. My guess is that a raised armboard would be the preferred method of roughing the height, with the final adjustment being done by the tonearm.
viridian's avatar
viridian
4,184 posts
 
With Grados, I had luck with the Morch UP-4, the SME series lll and, of all things, the Grace 747. Presumably the Grado arm would be an ideal match, and perhaps arms like the Forumula 4 and the Hadcocks that Bill Feil sells.
dekay's avatar
dekay
2,959 posts
 
OK, I understand.

I've considered the Denon as well, but the added expense of a suitable phono preamp, plus a synergistic arm, always makes me reconsider.

My 3009 non-improved (12.5g) works quite well with a Grado Prestige (Silver), but so did a Thorens TP13 once I got it dialed in.

Your Grado is 1.5g heavier than the Silver, which should not be a problem considering the amount of adjustment left on my counter weight.

If you wan't to squeeze more peformance from an old SME better factor in another $200+ for a rewire and rubber replacment.

I researched some of the best (IMO) vintage arms I would use -w- a 301 and they have gone up considerably in price over that past 3-4 years (way over $1K now).
stringreen's avatar
stringreen
5,112 posts
 
Rega arms do not have the best bearings. They are relatively soft SME has knife edge bearings...a better choice.
More to discover