1. Home
  2. analog
  3. 1350320370

VPI Platter Spinning SLOWLY

I've tried two different lubricants (Super Lube and Shimano Dura Ace Grease) for my VPI Classic 2 platter and it still does not spin properly. I removed and re-applied grease and it spins fine for about 5 minutes, then it slows down immensely. If I remove/re-install the platter, it spins smoothly again but only for a short period of time. Anyone experience this before and know a fix? Thanks
jyoungpark
jyoungpark OP
17 posts
 
@Pbnaudio
What is your method for pulling the bearing out to access the well?

Thank you all for the suggestions.
bpoletti
1,004 posts
 
Belt slipping?
jyoungpark OP
17 posts
 
The belt is slipping but only because the platter is seizing.
pbnaudio's avatar
pbnaudio
1,534 posts
 
You cannot pull out bearing just use a couple of paper towels and get out as much grease as you can from the female part, you have clearly overdone the grease. Brf is correct don't lubricate the shaft just put a dap of grease on the top of the top of the shaft at the ball bearing.

Good listening

Peter
bpoletti
1,004 posts
 
Clean and lightly talc the belt.

The Dura Ace grease should work very well. It's a sticky low-speed lubricant.

When the platter starts spinning slowly, is it really stiff? That motor has pretty high torque.

I'd call VPI. Everybody is back from RMAF.
More to discover