Soldering cable ends for AC terminations


Is it a good idea to cover the stranded cable ends with solder when assembling DIY AC cables or when sticking them in breakers in the AC panel? Some say it's not a good idea for high load connections as they may heat up and melt the solder. Is this true?
muratc
Jea48...I have no problem with solder in audio equipment, but there is electronic equipment that uses another method which sounds unlikely but actually works very well. I am thinking of "wire wrap". The soft copper wire is twisted around a hard sharp-cornered pin, while under tension using a special tool. This method was used for thousands of connections in the electronics assembly of a missile inertial guidance system that I worked on. Very reliable, even under extreme vibration during missile flight, and unaffected by nearby nuclear explosions, where solder would be melted by X-rays.
Eldartford, I agree with your post 100%. The method you describe was used in TVs for years, and found in some audio equipment as well.

As you know the old tube audio gear of the pre circuit board, the wire was held securely around a post or through a hole and doubled back for a metal to metal contact. The solder was only used to hold it in place. Solder has improved greatly. And as you know, solder is the only thing that holds resistors, caps, small power transformers, ect, to the circuit traces of a circuit board.
Jim
>>"and unaffected by nearby nuclear explosions, where solder would be melted by X-rays."<<
[Eldartford]
>>>>>>>

Eldartford, is it true that the Russians used vacuum tubes in their military equipment instead of transistors because tubes were not affected by the electromagnetic effect of a nuclear explosion?
Jim
Jea48...I doubt that the Russians did things much different from us. It would be quite impossible to implement anything but the most primitive guidance system using tubes. Our (US) late 1950's guidance system (Polaris Mk 1) was all solid state. Later, when radiation hardening became an issue, many features, most obviously, some shielding, were incorporated, but tubes were never considered. Many features of the hardware design, and the software which runs in it, have been developed to provide immunity to high levels of radiation.

There is one case where a tube was used in a recent design, and seriously considered for the most recent design. That is a Vidicon (optical imaging tube) used in space to sight on a star in order to correct for errors accumulated during the boost phase of flight. It was difficult to develop a CCD with the necessary radiation tolerance. Immunity to radiation was the only advantage of the vidicon.