Supporting Heavy Virtual Dynamics Power Cords


Hi Folks,
As much as I like the Power Cords from Virtual Dynamics, the weight and loose fitting female end of the cables does present a bit of a problem. Currently I put a sponge ball between the rack shelf and the power cord near the connection to the device. In essence one for the CPD, one for AMP and one for the PRE. Just wondered how some of you are compensating for power cords that do not fit snug into the back of devices. Other than that the cables are great (using Masters LE 2.0 Power Cords).
janmike
I wrap Blu Tack around the female connector. It makes the connection snug, but you still might need to support the weight of the cable with something.
I have a low rack ( no I am not an elderly woman ) so I use 2 large Porecelon Telephone Pole Insulators ( 8" high ) Works Great and looks good too..............
I have the same problem with Synergistic's Master Power Couplings. Very stiff, and heavy. My rack has a u-shape grill at the back-center, which I tie a dowel wrapped in wire-loom covering to. I then tie the power cord to the dowel. This works very well for me. Without doing something along these lines, there is trouble indeed.

Regards,
Dan
Here's a retain clip that may work

This doesn't fit all types (round vs square) type male IEC plugs ... but I'm sure you can fudge something together