2. cables
  3. 1231723826

can biwire cables be used on a non-biwire speaker?

I have a bi-wire AQ bedrocks that are being used with my 1.6s at the moment. The maggies are being sent off for modding this week. When they come back the new external x-overs accept non bi-wire only. I was wondering if I could use the bi-wires as a single run until I get new cables.

I don't want to get new cables first because the speakers will be gone before they'd get here and I want to hear the changes in sound from the mod by itself and not with the addition of new cables too.

They are terminated with banana plugs so I can't stuff two spade ends in.
adhaney
adhaney OP
50 posts
 
Thanks Al

They are the same gauge I think, but I will use the lower freq pair. In face before I box the speakers up I might go ahead and do that just in case there are any differences in sound.

thanks again!
almarg's avatar
Ag insider logo xs@2x
almarg
8,673 posts
 
You're welcome! You undoubtedly realize this, but just to be sure, if you try it with your present bi-wire speaker terminals you'll have to jumper the high and low frequency speaker terminals together.

Regards,
-- Al
adhaney OP
50 posts
 
yes. I just have to find the maggie jumpers.....

I also received an email from a member with AQ knowledge who informed me on how I could remove the banana plugs and combine the strands and make it essentially a full range single run.
weiserb's avatar
weiserb
469 posts
 
If your speakers have 5 way binding posts you can simply put banana connectors on the highs and spades on the lows and connect them both. I seen this used with excellent results on top of the line Nordost cables.
adhaney OP
50 posts
 
just an update.

Maggies are gone and so are the cables. Back to AQ to be reterminated :)

thanks for all the help.
More to discover