DIY Balanced Interconnect Connectors


I'm going to put together some Mogami 2534 cables for my balanced connection and I will be using Markertek as a source. They have a number of Neutrik connectors availabe, which would be the least expensive, functional type to get? There's different number of pins and such, can't figure out which one is needed for the Neglex. Also, if someone can point me to a good tutorial on assembling this type of cable, I've looked for about an hour and can't find one, you'd think there'd be a good step by step procedure out there.
smata67
I had a post on DIY balanced cables a few months ago. I ended up using the Newtrik NC3MX plugs in the post above.
You should be able to click on my threads when you read my post to get to all those answers in my post.
Smata,
You want a standard 3 pin connector, the Neutrik connector above NC3FXX is a great plug.
Pin #1 is your shield/ground wire(sometimes green).
Pin #2 is the white or red(+) wire
Pin #3 is the black(-) or return wire.

The female plug is the start of your signal path, so, if the wire you use is directional you want the signal to begin with the female plug(source) and end at the male plug, say your preamp or amp. Follow me?

Make sure you match pin to pin, in other words Pin #1 on one end of the cable(female plug) goes to Pin #1 on the other end of the same cable(male plug). Also make sure you have a female plug on one end of the cable and a male on the other(you'd be surprised some people mess it up!).

Don't forget that you want to put the plug body, clamp/strain relief and end plug on PRIOR to crimping/soldering your wires!!

If you are confused or get lost don't hesitate to contact me and I'd be happy to guide you through it, it's easy once you get the hang of it. You can email me directly at john@koolcables.com

I hope this helps you out some.

Best of luck,
John
"Don't forget that you want to put the plug body, clamp/strain relief and end plug on PRIOR to crimping/soldering your wires!!"

I've had to redo countless connections in the past and will most likely continue to have to re-do them in the future, but nice try.

I wanted a custom length, got the suggested connectors and 10' of wire for 2 interconnects, $35 shipped.
I'm not I get what you mean Smata, I was trying to help you not trying anything...