2. cables
  3. 1329160413

IC Failure

I recently had a failure in one of a pair of very high-priced, prestigious IC's. It simply has stopped transmitting a signal. I have swapped them out with other IC's in different components and definitely have isolated the problem to the IC. Both IC terminations are intact and solid. Can an IC short out?

Additional info: I just had the caps in my pre upgraded to Teflon, and this failure happened when I tried using my DAC. The suspect IC's ran from DAC to pre. All pre inputs, including CD and DVD, work fine with other IC's.

In almost 40 years of audiophilia I have never had this happen. Thanks for input. Want to hear from the cognoscenti before I go back to manufacturer.

Neal
nglazer
elizabeth
6,726 posts
 
It can just happen. No matter the cable is a $10 or $10,000 cable.
Contact the manufacturer, or your dealer.
It is no big deal. Even the best can have a problem.
ghosthouse's avatar
ghosthouse
3,718 posts
 
Do you have a multimeter? You can do a test for continuity across your suspect ICs.
marakanetz's avatar
marakanetz
5,473 posts
 
Yep you need to open and see the termination. These expensive pieces are often home made and the termination may suffer either lack of skill or equipment quality limitation for home use.

Open/Unscrew the RCA plugs of the malfunctioning interconnect and you'll see where the problem is. The issue itself is in short number of connecting and disconnecting the wires that get eventually stressed and than disconnected.

On my home-made interconnects I used Neutrik lockable RCA plugs. I can abuse these interconnects(pull them by the wire) and be worry free.
nglazer OP
734 posts
 
Thanks, all. I try to be gentle with IC's but my bet is there is a short. I do have have a multimeter. What am I looking for? Thx.

Neal
marakanetz's avatar
marakanetz
5,473 posts
 
WOW DMM MUST read short if there's no damage to IC. If IC isn't operation it should be OPEN circuit i.e. infinite resistance.
More to discover