Top resistors

Very interesting comments. I have tried in a DHT preamp the Audio Note, Shinkoh, Takman, Riken and Amtran resistors. They all sound different. I prefer the Shinkoh for a more realistic and natural. The metal film was more lively and open compared to the Shinkoh. Second to the Shinkoh was the Audio Note, very close but not as natural in tone or flesh sounding. I am able to switch the resistors on the fly as I built them into a rotary switch. Many people who have heard the preamp in "their" system agreed to my findings even though they did not know what resistor I was switching to. Not sure if I would get the same results in speakers or amplifiers as I have not tried this yet.

Happy Listening.

Bigkidz,

That rotary switch is great idea and thus provides instant results. Nice! I will have to try the Shinkoh's when I begin to "voice" my newly built phono pre.

It's good to keep in mind that I/all of us have different ears and listening priorities. I am voicing my amp to work with my sources and speakers in my room without a preamp.
It must be very difficult for the professional builder to voice an amp or preamp with so many variables to confront. I have been voicing my amp slowly for about a year.

Interesting comments Jetrexpro. It goes to show that longterm reactions are what matters, not quick conclusions after just a few hours. Thanks for sharing.
While my experience with Vishays is limited to the regular series, both nude and otherwise, I have to say your comments are very similar to my reactions. Vishays can sound too cool, lacking in warmth and emotion. IMO, they have their place but need to be used sparingly. For instance, I only have one in my system right now---as the grid stopper on the input tube for my SE amps. It works great there and helps to offset a tendency towards excess warmth.

Salectric,

I put the Tants on my cap burner for two weeks before installing into the amp circuit but even after that, their sound has been changing over the past four days. Last night they were starting to sound luxurious and rich but still maintaining detail and without that crispy upper mid/hi frequency etch of the older Tants.

More later.

Hi Response34, I was going to use some Mills MRA-12 for the power supply and as possibly plate resistor for my tube amp. But the new Mills resistors are now produced in Mexico, no longer in USA. Someone told me there's been some problems with the Mills made in Mexico. Have you had any issue with the new Mills?