Does silver speaker wire sound bright?

Again I agree with the first comment. Silver wire can be bright and hard initially but if you can let it mellow it will "soften up" in time. I have waited close to two hundred hours for silver interconnects and speaker cable to fully mature. The wait is worth it. Good luck.

All the silver interconnects and speaker cable I've had in my system have sounded different, just like all the copper ones. Break in is a factor, but I will admit that it's easier to have a bright silver cable than a bright copper one. There are other more important factors though, like AWG (for DC resistance), impedance, capacitance, etc..............I'm beginning to think that the little cheap MIT Terminator 3 speaker cable is better overall than my AudioTruth Dragon Plus, so the conductor material isn't always pivotal. Some guys swear by the carbon fibre conductors in Van den Hul cables, but I've never heard them.

Thank you all for the info. The speaker wire was a kit and I heard that silver was the best, so for the price I went for it. It is 15 awg cable consisting of a 22 awg, 20 awg and a 18 awg 5N silver wire. For the 6 foot pair, the cost was $229.00 and 2.5 hours of labor. I listened last night for about an hour and it did not seem quite as bad as before. Only time will tell.

Hi, I had the same problem initially. However, after reading about it on stereophile that one of the reviewers uses RF stopper to improve the situation. I tried it on mine and it solved my problem. RF stopper is not that expensive, you may want to give it a try. Regards, Simon

IMHO, you would have been better off just buying Music Metre Silver. It's 13 AWG, and I got mine for only $175 (a six foot pair). It's not manufactured anymore, but with a little searching, it's not that hard to find..............Anyway, I feel that any speaker cable whose gauge totals less than around 13 is going to have a tendancy toward brightness, except with single ended triode tube amps.