vinyl care VPI felt removal


Does anybody have any proven ways to remove the felt strips from the VPI vacuum tubes? I'm going to try to replace mine with strips from Nitty Gritty and don't want to damage the tube.
thx
jim gerace
jim_gerace
I think you can only get the strips on the tube. You just chuck the tube when its unusable. Here are two tips. First you can clean them with laudry detergent and a brush. Second you should clean really dirty records in two steps, and you should use a different tube for each stage. Since the tube for really dirty records will leave dirt on the pads, you don't want to pass this dirt on to another record. When I was really fanatical in the 70's, I had a four bath system for cleaning and only the absolute dirtiest records were ever sponged.
If you do not want to spend the $20+ for the Vpi replacement use the Disc Doctor replacements. They are easy to replace and come two sets for $11. Do not buy from Music Direct unless you want to spend $5 for shipping such a small item. BTW these work as well or better than the original. I am on my second set. Make sure you note where the old strips line up on the tube before pulling them off:)
Cheers, Bill
And don't ever clean the velvet strips with laundry soap, as the phosphate residue left behind will attach to the record. (Not a good thing)

Clean the velvet strips with the same record cleaning solution that you are currently using. Avoid using IPA (Iso-Propyl Alcohol) based solutions for cleaning the velvet strips, though, since the solvent may break down the glue used to hold the strips in place.

Avoid using tap water as a rinse, since most tap water is high in minerals. (Ever drain your hot water tank?) Imagine that on your record surface.