Is anyone in vinyl land familiar with ADC tonearms

Great stuff gang, would the cantilever on my Grado Platinum be considered high or low compliance? High meaning stiff (not good on a low mass tonearm) and low meaning cushioning (what I assume to be good, to dampen the blows per se) Or am I just confused.
Kind regards,
Michael

May I suggest you just try it and not ask anyone here. I don't mean that as a wise ass remark, its just that if I have it sitting here in front of me, and I think it might work, I usually try it. Your not going to hurt anything, and I personally happen to think it will work fine, but after that treatise that Sean wrote up there, I would defer to him. George Merrill is a good source though, and if you talk to him, tell him Pancho from 20+ years ago say hello. He is good audio.

Hi Mp: basically you need to know the effective mass of the arm & effective mass/compliance of the cartridge first. There are "general rules" as to what works best with what. I've read about this recently so I'll try to remember (for you) where I found the info. It was on a website: I think I have a hardcopy somewhere.

I found it - Refer to this link: Galen Carol Audio - tonearm / cartridge compatibility.
http://www.gcaudio.com/Archives/tonearmcartidge.htm

Bob, you are a gentleman, thank you.