vpi jmw tonarm rust yes rust


I just love the fact that my new vpi scout's tonearm is starting to rust. I thought it was aluminum. Either way this is rediculous for a product with it's reputation. If I had a digital camera I'd post some pics.
128x128toddwj
The web site says the arm is stainless steel. Again I suggest calling VPI. They are very very helpful.
Just a note,there are many grades of stainless steel.The higher the grade# the better.Lower grade#s will rust,Surfice rust only.Higher grade#s do not .Just try [Theo]`s idea, the wd40 will more than likely remove it.It is only on the surfice.Is your equiptment located in a high humidity area?If your sound room is in a basement you may want to check the humidity level.You may be slowly getting rust inside your audio equiptment.You may have to install a dehumidifier.Just so I don`t get yelled at,I am not saying VPI is using cheap SS.The grade they are using I am sure they have a reason.Ask them.
no rust here, but the damping oil for the jmw arm attracted some (desparate) ants- quite a few of them. i got rid of the oil and rubbed a little black flag on my precious plinth!
i hope this doesn't screw up the sound too much...
i don't want to be the science teacher here, but metal corrodes in the repeated presence of liquids - perhaps used in the record-cleaning routine of certain persons...
I would be more concerned about the chemicals in the Black Flag you rubbed on the the plinth of your VPI.Have you read what`s in there.
The entire Tonearm is not aluminum, nor stainless-steel it is Bead Plasted for a Matte Finish, then Industrial Hard-Chromed. If it was touched with sweaty fingers & not wiped off during high humidity and the table covered it will rust in time. Industrial Hard Chroming is to be able to withstand 500-2000 hours of salt-air exposure in a ventilated enviorment. However in a non-ventilated it will pit/brown in a matter of 48-72 hours. Call VPI see if they had any other reports, as I'm sure they have them done by a sub contracted outside facility. It may have been a bad chroming batch they received, & VPI quality control will not spot it till it fails by the end user. I too am a VPI owner, however I have no issues with my arms finish. Do not use WD-40 as it attracts dust, & you don't want to take the chance of getting any type of lubicating fluid near your Cartridge. Good Luck!