2. cables
  3. 1013749426

How does MIT vary the impedance of their cables?

Hi,
I have a pair of MIT 330's that are "medium" (47~100ohms) and I need "low" (10~47ohms).
I was wondering how MIT alters the impedance in their different versions? I'm guessing that it's with the use of a resistor in the network box? I thought that if I could open the box and jumper the resistor... Any opinions?
Thanks,
Paul.
peleon
mikie
24 posts
 
Regarding the Modification of Said Manufactures Networks Boxes, You are out of Luck, All Resistor/Capacitors combos are epoxy filled within internal container... The Solution to your interest is Zobel Networks, research this topic for possiblities.
Ag insider logo xs@2x
joeabrams
132 posts
 
Dear Paul,

The L,M H deignations DO NOT refer to the resistance of the cable. They refer to the input impedance of the component that the cable is designed to MATCH. You can email MIT at whatever@mitcables.com or call them at 916 625 0129.

Best of luck,
Joe
cornfedboy
1,645 posts
 
peleon: you can get into the mit network box if you really care to. all it takes is a sawzall, a cold-forged chisel and an 8 pound hammer. 'course if you take this route, you should be prepared to discover that there's nothing to it but the epoxy resin. -cfb
More to discover